Got them mostly installed today. Had to lengthen a couple holes to make them line up, but I'm sure production tolerances come into play here.

A couple things should be noted:
-they only come with a rough coat of paint to prevent surface rust, they need to be prepped and painted before installing
-you cannot use the factory mounting hardware at the nose (two nuts and one plastic plug on each side) as they all hit the insert due to the washers on them. I plan on getting some standard 10mm nuts with smaller washers, and will get some new plastic plugs and trim the bottom off to make it fit

Other than that, they fit pretty decent and do clean up the look of the area.